Stage lighting dimming equipment and lighting installation system

(1) After the preliminary construction of stage lighting power cables, signal wiring and plug-in connectors is completed, the installation of dimming equipment and lamps will be carried out. (2) Put the dimming equipment into the construction site one by one according to the construction sequence. In order to ensure the quality of equipment installation, after the equipment unpacking inspection procedure is implemented, the electrical and mechanical performance of the equipment shall be tested according to the parameters provided by the equipment technical documents. Then install the device. (3) The equipment installation process needs to cooperate closely with civil engineering, ventilation, air conditioning, water supply and drainage, weak electricity, decoration, etc., arrange electrical engineering construction according to the progress of the building project, and actively cooperate with the decoration unit during the decoration process. The installation position of the switch is reserved accurately to avoid damage to the decoration during installation.

(4) During the construction process, strict protective measures must be taken when grooves and holes are made on the walls, floors, indoor roofs, and roofs of outdoor buildings, and restoration must be completed in time after construction. (5) For the holes left on the walls and floors, except for the design requirements, the remaining holes should be sealed or separated for fire protection after the pipeline construction is completed. (6) For the sake of completeness, the face light bridge and the slap room can only be installed with lamps after the site acceptance.

(7) The installation of lamps and lanterns on all electric systems must be controlled by relevant construction units sending personnel to assist.